Publicidad
OPERATING INSTRUCTIONS
7. Adjustable Torque Clutch
The torque clutch can be adjusted to 23 driving
settings and 1 drilling setting.
Adjust the torque by rotating the torque adjustment
ring (B). The higher the torque setting number,
the more force the drill/driver produces to turn an
object.
The proper setting depends on the job and the type
of bit, fastener, and material you will be using. In
general, use greater torque for larger screws. If the
torque is too high, the screws may be damaged or
broken.
Select the drill setting
heavy-duty applications.
NOTICE:
• Do not change the torque setting when the tool is running.
8. Installing and Removing the Belt Clip
a. Align the rib of the belt clip (H) with the hole on
the base of the drill/driver.
b. Insert the screw and tighten the screw securely
with a Phillips-head screwdriver (not included).
c. To remove the belt clip, use a Phillips-head
screwdriver to loosen the screw holding the belt
clip to the drill/driver.
NOTE: The belt clip can be installed on the right or
left side of the tool.
9. Installing and Removing the Bit Holder
a. Align the rib of the bit holder (I) with the hole on
the base of the drill/driver.
b. Insert the screw and tighten the screw securely
with a Phillips-head screwdriver (not included).
c. To remove the bit holder, use a Phillips-head
screwdriver to loosen the screw holding the bit
holder to the drill/driver.
NOTE: The bit holder can be installed on the right
or left side of the tool.
for drilling and other
7
B
B
8
9
12
H
Screw
I
Publicidad
