Atlas Copco P Serie Manual De Instrucciones página 22

– It is advisable to check the specific gravity of the
electrolyte at least once every hour to prevent
overcharging the battery.
Never smoke or make and break
connections at the battery while
charging. Sparks may ignite the
battery gas.
Battery electrolyte is poisonous and
dangerous, causing severe burns,...
as it contains sulphuric acid. Avoid
contact with skin, eyes or clothing.
When electrolyte has been spilled, perform the
following actions:
– Contact with skin/clothes: Flush with water.
– Swallowing: Drink large quantities of water or
milk, continue with milk of magnesia, beaten egg
or vegetable oil. Call immediately a physician.
– Contact with eyes: Flush with water for 15
minutes and get prompt medical attention.
Batteries produce explosive gases.
Keep away sparks,
cigarettes,... Ventilate when charging
or using in closed space.
Always cover eyes when working
near batteries.
Keep batteries out of reach of
children!
4.3.5 AC parallel operation
Before connecting an appliance to a
generator set, make sure that it is in
good working order and that its
electrical rating does not exceed the
electrical rating of the receptacle.
During parallel operation, the ESC-
throttle switch should be in the same
position on both generator sets
1. Connect the parallel operation cable between the
generator sets following the instructions supplied
with the cable kit.
2. Start the engines and make sure the output
indicator (green)
illuminates.
3. Plug an appliance into the AC receptacle.
4. Turn on the appliance.
Operating principles
– Make sure that the appliance is in good working
order. A faulty appliance or power cord can create
flame,
a potential for electrical shock.
– If an appliance begins to operate abnormally,
becomes sluggish or stops suddenly, turn if off
immediately. Disconnect the appliance and
determine whether the problem is situated in the
appliance or if the rated load capacity of the
generator set has been exceeded.
– Make sure that the combined electrical rating of
the tools or appliances do not exceed the electrical
rating of the generator.
– Never connect different generator set models.
– Do not remove the parallel operation cable when
– For single generator set operation, the parallel
on each generator set
- 22 -
the generator set are operating.
operation cable must be removed.
Substantial overloading
continuously lights the overload
indicator (red) may damage the
generator set. Marginal overloading
that temporarily lights the overload
indicator (red) may shorten the
service life of the generator set.
For continuous operation, do not
exceed the rated power.
Rated power in parallel operation is
6 kW.
that