Audio Settings; Audio Control - JVC KD-X352BT Manual De Instrucciones

AUDIO SETTINGS

1
Press and hold .
2
Turn the volume knob to select an item (see the following table),
then press the knob.
3 2
Repeat step until the desired item is selected/activated or follow
the instructions stated on the selected item.
4 Press to exit.
To return to the previous setting item, press
EQ SETTING
PRESET EQ Select a preset equalizer suitable to the music genre.
• Select [USER] to use the settings made in [EASY EQ] or [PRO EQ].
FLAT/DRVN 3/DRVN 2/DRVN 1/HARD ROCK/HIP HOP/JAZZ/POP/
R&B/USER/CLASSICAL
Drive equalizer (DRVN 3/DRVN 2/DRVN 1) boosts specific frequencies in
the audio signal to reduce the noise heard from outside the car or running
noise of the tyres.
EASY EQ Adjust your own sound settings.
• The settings are stored to [USER].
• The settings made may affect the current settings of [PRO EQ].
SUB.W SP * *
1 2
:
SUB.W * 1 * 3
:
BASS:
MID:
TRE:
18
ENGLISH
.
00 to +06 (Default: +03
–50 to +10
LVL–09 to LVL+09
LVL–09 to LVL+09
LVL–09 to LVL+09
PRO EQ
62.5HZ
LEVEL –09 to LEVEL +09 (LEVEL 00): Adjusts the level to memorize for each source.
(Before making an adjustment, select the source you want to adjust.)
ON: Turns on the extended bass. ; OFF: Cancels.
100HZ/160HZ/250HZ/400HZ/630HZ/1KHZ/1.6KHZ/2.5KHZ/4KHZ/6.3KHZ/10KHZ/
16kHZ
LEVEL –09 to LEVEL +09 (LEVEL 00): Adjusts the level to memorize for each source.
(Before making an adjustment, select the source you want to adjust.)
Q FACTOR

AUDIO CONTROL

Default: XX
BASS BOOST
LOUDNESS
SUB.W LEVEL * 1
00
SUBWOOFER
LVL 00
SET *
3
LVL 00
* 1 , * 2 , * 3
LVL 00) : ( 19)
Adjust your own sound settings.
• The settings are stored to [USER].
• The settings made may affect the current settings of [EASY EQ].
1.35/1.50/2.00: Adjust the quality factor.
LEVEL +01 to LEVEL +05: Selects your preferred bass boost level. ;
OFF: Cancels.
LEVEL 01/LEVEL 02: Boosts low or high frequencies to produce a well-
balanced sound at low volume. ; OFF: Cancels
SPK-OUT * 2
(Not applicable when 3-way crossover is selected.)
SUB.W 00 to SUB.W +06 (SUB.W +03): Adjusts
the output level of the subwoofer connected via
speaker lead. ( 31)
PRE-OUT * 3
SUB.W –50 to SUB.W +10 (SUB.W 00): Adjusts
the output level of the subwoofer connected to the
lineout terminals (REAR/SW) through an external
amplifier. ( 31)
ON: Turns on the subwoofer output. ; OFF: Cancels.