Publicidad
Idiomas disponibles
Idiomas disponibles
To change the batteries of the Remote Control Lens Cap, simply open the Battery
Door
at the bottom of the Remote Control Lens Cap by sliding it. Then install
rc4
one CR1632 battery (3 V) and close the Battery Door rc4.
TROUBLESHOOTING
The camera is functioning but the film does not eject after the Shutter
q
Release Button / Self–Portrait Mirror
Please check the following:
a
Make sure that the camera is turned on and focus is set to either 0.6 m,
e
/ 1–2 m / infinite.
Make sure there is film installed in the camera.
e
Check the Film Counter Indication LED 3, if the lights are blinking quickly
e
then your film has come to an end and needs to be replaced.
Check whether the MX Mode Indication Light
e
is on. If it is, that means you are in the MX Mode. Press the MX Button
again to switch off the MX Mode.
Look at the Shooting Mode Indication Light
e
power, if it's blinking, it's time to change the batteries.
The automatic exposure seems to be incorrect, my subject is under– or
q
overexposed.
is pressed.
7
above the MX Button
17
to check the battery
18
16
16
ENGLISH / 17
Publicidad
