Publicidad
POWERING OFF
1
To power off, place the earbuds in the charging case and close it.
The earbuds will automatically power off after 10 minutes if they are not
connected. The duration can be set in the soundcore app.
LED LIGHT GUIDE
1
Flashing white rapidly
Flashing white slowly
Steady white
Light off
SPECS
Specifications are subject to change without notice.
Input
Rated output power
Battery capacity
Charging time
Playtime (Music Mode)
Playtime (Sleep Mode)
Driver unit
Frequency response
Impedance
Waterproof level (earbuds)
Bluetooth version
Bluetooth range
2
PAIRING
1s
CONNECTED
5s
< 5%
5s
5% - 30%
30% - 70%
5s
5s
>70%
5V
0.5A
2.2mW
25mAh x 2 (earbuds);
580mAh (charging case)
Up to 2 hours
Up to 6 hours (Total 47 hours
with the charging case)
Up to 10 hours (Total 80 hours
with the charging case)
5mm dynamic driver
20Hz - 20kHz
IPX4
5.2
10m / 33ft
RESET
1
Reset if the earbuds have issues pairing with each other or with other
devices.
Delete the pairing history from your Bluetooth device first. Place the
earbuds in the charging case and leave the case open. Press and hold
the button on the charging case for 10 seconds until the LED indicators
rapidly flash white 3 times.
FIRMWARE UPDATE
You will be informed once the new version of firmware is detected when
you connect the earbuds with the app. Ensure the earbuds are placed in
the charging case and the case remains open until the firmware update
is completed. During the update, ensure the earbuds are being charged
and avoid any usage.
Phone call function is not supported on soundcore Sleep A10. Please
use your mobile phone to answer a call.
EN 03
2
10s
×3
2
1
Publicidad
