Maintenance; Troubleshooting - Ryobi P435 Manual Del Operador

WARNING:
When servicing, use only identical replacement parts.
Use of any other parts can create a hazard or cause
product damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
Problem
Wax does not go on evenly.
Polishing seems difficult.
Polisher does not turn on.
Pad spins slower than normal or not
at all.
NOTE: ILLUSTRATIONS START ON PAGE 8 AFTER

MAINTENANCE

TROUBLESHOOTING

Too much wax on the bonnet.
Bonnet may be worn.
Battery is not charged.
Problem with motor.
Motor needs to be serviced or replaced.
FRENCH AND SPANISH LANGUAGE SECTIONS.
This product has a Three-year Limited Warranty.
For Warranty details go to
www.ryobitools.com
APPLICATION AND BUFFING/POLISHING
BONNETS
Both the application and buffing/polishing bonnets are
reusable. For maximum life and performance, hand wash
after use and allow them to air dry. If needed, the bonnets
can be machine washed in cold water with a small amount
of detergent, then machine dried using low heat.
FOAM PAD
It is important that the pad retain its original shape and
dimensions. Allow it to dry completely after each use. Make
sure to remove the bonnets, wash them, and store separately.
Polisher should be stored with the pad facing up in order to
extend pad life and retain its shape. Be careful not to use
too much polish at one time. If the pad becomes saturated,
it will not last as long.
Possible Cause
7 – English
Solution
Remove a portion of the wax and retry.
Replace bonnet.
Charge battery
Call authorized service center.
Call authorized service center.