Whirlpool 20K Manual Del Usuario página 50

STORAGE AND TIPS FOR USING THE
REMOTE CONTROL
How to insert the batteries
I . lnsert a pin and gently press down on the
battery cover and push in the direction of the
arrow to remove, as shown.
2. lnsert 2 AAA batteries (I .SY) into the
compartment.
Ensure that "+" and "-" polarity is correctly
positioned.
3. Close the battery cover on the remote contrai.
How to remove the batteries
Remove the battery cover in the direction of the
arrow.
Press the positive pole of the battery softly with
your fìngers, then draw the batteries out of the
compartment. AII this should be done by adults,
children are forbidden to remove the batteries
from the remote contrai in arder to avoid danger
of swallow.
Disposal of the batteries
Please discard the batteries as sorted municipal
waste at the accessible collection point.
Precautions
• When replacing the batteries, do not use new
batteries with old batteries, or different types of
batteries as this may cause the remote contrai
to malfunction.
• lf you do not expect to use the remote contrai
for some time, take the batteries out to prevent
leakage of battery acid in the remote contrai.
• Operate the remote contrai within effective
range. Keep the remote contrai at least I meter
from any TV set or HI-FI equipment.
• lf the remote contrai does not work normally,
take the batteries out and reinstall after 30
seconds. lf it stili does not work install new
batteri es.
• To operate the appliance by remote contrai,
point the remote contrai at the receiving device
on the indoor unit, to ensure receiving
sensibility.
• To send a message from remote contrai, the
symbol � will flash for I second. On receipt
of the message, the appliance will emit a beep.
Signal receptor
• T he remote contrai will operate the air
conditioner at a distance of up to 7m.
• Each time the batteries are replaced in the
remote contrai, the remote contrai is pre-set at
Heat Pump mode.
50