cecotec bolero DRESSCODE 8400 INVERTER Manual De Instrucciones página 45

ENGLISH
3. PRODUCT INSTALLATION
Place the device on a flat, stable and dry surface. Make sure the product does not stand on the
power cord.
Fig. 3.
Avoid direct sunlight and ensure sufficient ventilation.
Fig. 4.
Remove the cardboard box and Styrofoam packing.
Lift the washing machine and remove the base packing. Make sure the small triangle foam is
removed with the bottom one together. If not, lay the unit down with on the side surface, then
remove the small foam from the unit bottom manually.
Fig. 5.
Remove the tape securing the power supply cord and drain hose.
Remove the inlet hose from the drum.
Removing the transport bolts
The transport bolts must be removed from the backside of the device before using it.
The transport bolts will be necessary again when moving the product, so make sure they are
kept in a safe place.
In order to remove the bolts:
Fig. 6.
Loosen 4 bolts with a spanner and then remove them.
Stop the holes with transport hole plugs.
Keep the transport bolts properly for future use.
Leveling the washing machine
Warning: The lock nuts on all four feet must be screwed tightly against the housing.
Check if the legs are closely attached to the cabinet. If not, please turn them to their original
position and tighten the nuts.
Loosen the lock nut to turn the feet until it closely contacts with the floor.
Adjust the legs and lock them with a spanner. Make sure the machine is steady.
Fig. 7.
Water supply hose connection
Warning: Do not kink, crush, modify or sever the water inlet hose.
For the models equipped with hot valve, connect it to a hot water tap with the hot water supply
hose. Energy consumption will decrease automatically for some programs.
Connect the inlet hose following one of the below methods:
Connection between ordinary tap and inlet hose.
Fig. 8.
45
BOLERO DRESSCODE_8400 INVERTER / 9400 INVERTER / 10400 INVERTER