cecotec bolero DRESSCODE 8400 INVERTER Manual De Instrucciones página 7

grounded.
If the supply cord is damaged, it must be replaced by the
Technical Support Service of Cecotec or by a similarly qualified
person in order to avoid a hazard.
This appliance is for indoor use only.
Make sure the device is installed in places where temperature
is above 0 ºC.
The device is not designed for built-in installation.
The new hose-sets supplied with the appliance are to be used
and that old hose-sets should not be reused.
Before any maintenance the device, unplug the appliance from
the mains.
Always unplug the machine and turn off the water supply after
use. The max. inlet water pressure, in pascals. The min. inlet
water pressure, in pascals.
Never pull out power plug with wet hand.
Please remember to disconnect water and power supply
immediately after the clothes are washed.
Pull out its plug from the power socket before cleaning or
maintenance.
To ensure your safety, power plug must be inserted into an
earthed three-pole socket. Check carefully and make sure that
your socket is properly and reliably earthed.
Make sure that the water and electrical devices must be
connected by a qualified technician in accordance with the
manufacturer's instructions and local safety regulations.
The glass door may be very hot during operation. Keep kids and
pets away from the machine during the operation.
Do not operate the device in very wet rooms or in rooms with
explosive or caustic gas.
Adequate ventilation has to be provided to avoid the back flow
of gases into the room from appliances burning other fuels,