cecotec bolero DRESSCODE 8400 INVERTER Manual De Instrucciones página 53

ENGLISH
Warnings:
After a program is completed, wait for two minutes before opening the door.
Check whether the water inside the drum has been drained before opening its door. Do not
open the door if there is any water visible.
Never stop the device before the end of the drying cycle unless all items are quickly removed
and spread out so that the heat is dissipated.
Do not wash only one piece of clothes or garment, as these could cause great unbalance.
Always introduce at least 3 or 4 clothes so that draining can be done smoothly.
5. CLEANING AND MAINTENANCE
Warning: Before cleaning or maintaining, unplug the appliance and close the tap.
Proper maintenance on the washing machine can extend its working life. The surface can be
cleaned with diluted non-abrasive neutral detergents when necessary. If there is any water
overflow, use a cloth to wipe it off immediately.
Fig. 25.
Do not use abrasive cleaners or scouring pads to clean the product.
Cleaning the drum
The rusts left inside the drum by the metal articles shall be removed immediately with
chlorine-free detergents.
Do not use steel wool.
Note: Do not put laundry in the washing machine during the drum cleaning.
Cleaning the door seals and glass
Wipe the glass and seal after each wash to remove lint and stains. If lint builds up it can cause
leaks.
Remove any coins, buttons and other objects from the seal after each wash.
Fig. 26.
Cleaning the inlet filter
Note: The inlet filter must be cleaned when there is little water.
Washing the filter in the tap
Fig. 27.
Close the tap.
Remove the water supply hose from the tap.
Clean the filter edge.
Reconnect the water supply hose.
53
BOLERO DRESSCODE_8400 INVERTER / 9400 INVERTER / 10400 INVERTER