Kärcher BR 30/15 C Manual Del Usuario página 12

Operation
 Vacuum loose dirt with a vacuum clean-
er prior to cleaning.
 Swivel the pushing handle lock to the
outside, set the desired pushing handle
height and close the lock.
 Insert the mains plug into the socket.
ATTENTION
Risk of damage. Check the object to be
cleaned prior to using the appliance in an
inconspicuous place for colour fastness
and water resistance.
DANGER
Risk of electric shock.
Do not let the mains cable come in contact
with the rotating brushes or rotating pads.
 Set the appliance switch to normal op-
eration - start the suction turbine and
the brush drive.
 Use the detergent solution key on the push
bow to spray on detergent solution.
 Run across the surface to be cleaned in
overlapping paths. Pull the appliance
backwards during this procedure (do
not push).
Emptying the waste Water tank
 If the waste water tank is filled to 3/4 of
its capacity, switch the appliance switch
to "OFF".
 Swivel the domelock to the front.
 Lift the waste water tank off the appli-
ance and empty it.
WARNING
Please observe the local provisions regard-
ing the wastewater treatment.
NOTICE
If the waste water tank is full, dirty water will
flow back onto the carpet, as soon as the
appliance is switched off.
Operation with accessory tools
Only use accessories and spare parts
which have been approved by the manu-
facturer. The exclusive use of original ac-
cessories and original spare parts ensures
that the appliance can be operated safely
and trouble free.
12
 Connect the provided adapter to the de-
tergent hose of the accessory tools.
 Pull the suction hose out of the dome.
 Insert the suction hose of the accessory
tool into the dome instead of the suction
hose.
 Connect the coupling of the detergent
hose on the appliance to the detergent
hose of the accessory tool.
 Set the appliance switch to operation
with manual nozzle - the suction turbine
will start.
 Use the lever on the accessory tool to
spray on detergent solution.
Important
When unplugging the accessory tools, the
adapter must be removed from the appli-
ance, so that the water output on the appli-
ance is closed.
Recommendation: Leave the adapter on
the hose of the accessory tool.
– Highly soiled spots should be pre-
soaked and the detergent solution
should soak 5 to 10 minutes.
– Always work from the light to the shade
(from the window to the door).
– Always work from the cleaned to the un-
cleaned surface.
– The more sensitive the surface (oriental
rugs, berbers, upholstery material) the
lower the cleaning solution concentra-
tion should be.
– Rugs with jute backing can shrink if too
much water is used and can bleed col-
ours.
– 3
EN
Cleaning tips