Publicidad
Idiomas disponibles
Idiomas disponibles
BEFORE FIRST USE
Carefully remove the product and accessories from the original packaging. It is recommended to store the
original packaging for later storage. If you wish to dispose of the original packaging, you will do so in
accordance with the applicable legal provisions. If you have any questions about the correct disposal, ask
your local authority.
Check the packaging contents for completeness and damage. If the packaging content is incomplete or if
damage is detected, please contact your point of sale immediately.
Clean the product after unpacking; see section Cleaning and Care.
Note
Please note the minimum space area of 9 m2. (see table on page 6)
INSTALLATION
Location
Keep the following points in mind when choosing the installation location:
Observe all safety instructions!
Keep an environmental distance of 30 cm on the side and 100 cm frontally/rear to other electrical
appliances.
On the rear, keep an environmental distance of 50 cm around the outer exhaust air wall outlet and
protect it from incoming objects or moisture.
Make sure that the wall behind the product is an outer wall and not a partition wall, and that any holes
in the outer wall can be carried out safely, note lines inside the wall if necessary.
Make sure that a suitable power outlet is within range and that it remains accessible after installation.
Be aware that water accumulates in the product during the operation/dehumidification process, which
must be dissipated continuously with the supplied drainage hose into a suitable container or drain.
Make sure that no obstacles block the airflow.
DO NOT cover the inputs, outputs or the remote control signal receiver
product, as this may result in damage to the product.
Note
If the product has been tilted or laid during transport, wait at least 24 hours after erecting to
avoid possible damage to the cooling system.
page 10
Publicidad
