Publicidad
Idiomas disponibles
Idiomas disponibles
Care
CLEANING AND CARE
Cleaning
Fig. 11
Turn the device into standby and unplug the power plug to disconnect it from the power supply.
Note
Clean the device approximately every two weeks. Clean the outer surfaces of the device with a
damp cloth and neutral cleaning agent. Dry the device with a lint-free cloth. Do not use chemical,
alkaline, smirting or other aggressive detergents as they can damage the surfaces.
Fig. 12
Remove the air filter. Clean the air filter in warm water (< 40 °C) and with neutral detergent
Fig. 13
Allow the filters to dry completely before installation.
Decommissioning
Empty any water from the device and dry it for half a day in fan mode Fan in a dry, warm room to
prevent mold.
Turn the device on standby. Unplug the power plug and attach the power cord to the power cable
loop. Remove the exhaust hose assembly from the device.
Close the cover of the wall adapter. Cover the processes.
Remove the batteries from the remote control.
Transport
Attention - the device is heavy. Therefore move the product by pushing or pulling on the rollers if
possible.
If lifting is unavoidable, use the recessed grips and carry the product in pairs.
Do not move the product during operation. Wait at least two hours after moving the product before
operating it to avoid damage to the refrigerant circuit.
page 17
Publicidad
