Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
Power on/off
The device can only be switched on or on standby.
Press the on/standby button
Notes
After a power failure or when the product is in standby and shortly afterwards switched on again, the
cooling compressor starts after 3 minutes (switch-on delay).
This is to prevent damage to the refrigerant circuit. If the product is knocked over, switch to standby
immediately and pull the plug. Wait at least 2 hours before restarting the appliance to prevent damage
to the refrigerant circuit.
Always switch the product to standby before unplugging it.
Remote control
Remove the battery compartment cover and remove the battery protection strip.
The remote control is therefore ready for operation. If no batteries have been inserted yet, place 2
batteries (type R03/ AAA) into the battery compartment. Observe the correct polarity. Close the
battery compartment with the lid.
The alternating use of the control panel and the remote control may cause a deviation of the
product and the information displayed on the remote control. As soon as a button oftheremote
operationis pressed, the device takes over the settings of the remote control.
Notes
The signals of the remote control are transmitted with a short delay. This process is indicated when
appears in the display of the remote control at the top left.
the icon
page 12
or the ON/OFF button to turn the product on or off or into Standby.
Publicidad
