TRINNITY KLMO26 Manual De Instalacion Y Uso página 38

Setting lamellas
Fig. 8
Manually adjust the lamellas so that the airflow is directed in any direction. This is possible in all
modes.
Attention: Take care of this!
Setting the timer
The timer switches the unit on or to standby after the set time has elapsed. When the unit is
switched on, it uses the mode and setting last used.
The set duration is counted down immediately after the setting is made.
TIMER ON Press the button to activate the auto-on time setting.
Each time you press the button, the time setting increases in increments of
30 minutes, up to 10 hours, then in increments from 1 hour to 24 hours.
To cancel the Auto-On time setting, simply press the button until the
time setting is 0.0
TIMER OFF Press this button to enable the auto-off time setting.
Each time you press the button, the time setting increases in increments of
30 minutes, up to 10 hours, then in increments from 1 hour to 24 hours.
To cancel the time setting Auto-Off, simply press the button until the
time setting is 0.0.
Examples:
To switch the device off after 1 hour and back on after another 1 ½ hours,
set the auto off time to 1.0 h and the auto on time during operation
to 2.5 h.
To turn on the unit in 8 hours for a period of 8 hours, set in standby the
auto on time to 8.0 h and the auto off time to 16.0 h.
Notes:
The setting is made in 0.5 steps up to 10 hours and 1 hour steps from 10 up to 24
hours.
The respective control lamp lights up when a time is set. The settings
are deleted if the product is manually switched on or in standby before the time
has expired.
After the auto-on/off command is executed, the setting is deleted and the device must be set again.
The settings are also deleted if an error occurs (see Protection and error codes).
After the auto-on/off command is executed, the setting is deleted and the device must be set again.
The settings are also deleted if an error occurs (see Protection and
error codes).
page 15