Descargar Imprimir esta página

Angelo Po SMOK Manual De Uso página 108

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Important
Before it is put into service, the system must
be tested to check the operating conditions
of every single component and identify any
malfunctions. In this stage, it is important to
check that all health and safety requirements
have been complied with in full.
To test the system, make the following checks:
Check that the mains voltage is the same as
1)
that of the appliance.
The appliance's main functions do not require
any special adjustments by specialist staff except
the settings made during use by the user.
INSTRUCTIONS AND WARNINGS FOR THE REPLACEMENT OF PARTS
The appliance's main functions do not require
any special adjustments by specialist staff except
the settings made during use by the user.
GB
EQUIPMENT DECOMMISSIONING, DEMOLITION AND DISPOSAL
When decommissioning the appliance, a series of
procedures must be carried out to ensure that the
appliance and its components are not a hindrance
and are not easily accessible.
To ensure that the appliance cannot constitute
hazards for people or the environment, all ener-
gy sources (electricity, etc.) must be disconnect-
ed and rendered unusable, and any liquids pre-
sent must be drained (lubricants, fl uids, etc.).
Place the appliance in a suitable area which is not
easily accessible, with barriers to prevent anyone
from accessing it.
3329690_inst_GB
TESTING OF THE APPLIANCE
ADJUSTMENTS
INSTRUCTIONS AND WARNINGS FOR ADJUSTMENTS
ADJUSTMENTS
Turn on the master switch to check the electri-
2)
cal connection.
Check that the safety device is operating cor-
3)
rectly.
After testing, if necessary instruct the user in all
the skills necessary for putting the appliance into
operation in conditions of safety, in accordance
with legal requirements.
When scrapping, sort all components by chemi-
cal characteristics and dispose of them separate-
ly in accordance with the relevant legal require-
ments.
Important
Do not dump non-biodegradable products,
lubricating oils, and non-metallic compo-
nents (rubber, PVC, resins, etc.) in the envi-
ronment. Dispose of them in compliance with
the relevant laws.
- 8 -
ITALIANO

Publicidad

loading