STERWINS PBC1-26L-AB.2 Manual De Instrucciones página 259

DANGER! Risk of injury due to accidental start.
therefore check the product using this section. In most cases the problem can
be solved quickly.
Probable causes
Problems
The switch was set to STOP.
The fuel tank is empty.
The primer bulb was not
pressed enough.
Engine does
not start
Spark plug is defective.
The fuel tube is broken.
Engine lack Spark plug is dirty .
of power or
engine does
not accelerate
Fuel mixing screw is set
incorrectly.
The lengths of two ends
Unsatisfactory
cutting
performance
Blunt or broken metal blade Sharpen or replace blade.
The metal blade is installed
Excessive
incorrectly.
vibration/
noise
Bolts/ nuts are loose.
The engine
will not idle
Idle screw is set incorrectly.
5. TROUBLESHOOTING
Corrective actions
Set the engine switch to the ON («I») position.
Refuel the fuel tank with properly mixed fuel.
Press the primer bulb 4-7 times or until fuel is
visible.
Clean the electrode or change with a new one.
Remove the spark plug and wipe up the fuel,
then pull out the starter rope 5-10 times to drain
out the fuel in cylinder.
Contact with the local service center for repair.
Clean it.
Contact with the local service center for help.
Tap the trimmer head against the ground
automatically.
Make sure the metal blade aligns with the output
spindle.
Tighten bolts/nuts.
Contact with the local service center to adjust the
idle speed.
257
EN