7.11. Dimmer function
You can set the display brightness to two levels:
Press the DIMMER button several times until the required brightness has been
set.
7.12. Setting the language
You can select the following languages for the applicable menu language: English,
German, Italian and French.
Press and hold the MENU button until the menu is shown on the display.
Press the or buttons to select SYSTEM.
Press to open the system settings.
Press the or button to select LANGUAGE (depending on the language
set, this may also be called LANGUE, LINGUA or SPRACHE).
Press to open the language settings.
Press the or buttons to select your preferred language.
Press to confirm the selected language.
7.13. Setting the time and date manually
When the device is switched on for the first time, it automatically sets the date and
time using the radio signals. Manual setting is not usually necessary. If this is neces-
sary as a result of poor signal reception, proceed as follows:
Press the CLOCK button. The hour then flashes on the display.
Press the or buttons to set the desired hour and press to confirm.
Press the or buttons to set the desired minutes and press to confirm.
Press the or buttons to set the desired day and press to confirm.
Press the or buttons to set the desired month and press to confirm.
Press the or buttons to set the desired year.
Then press the button to confirm and store the configured settings.
You can configure additional manual settings for the time and date. An overview of
the entire device menu is available in section "15. System menu" on page 64.
8. Switching on the device/standby
Press the
button to switch on the device.
Press the
button again to switch the device back into standby mode. The
time is displayed and the standby LED lights up.
9. Radio mode
You can use this device to receive FM and DAB stations.
Your device has the Dynamic Label Segment (DLS) information service, which dis-
plays information such as artist, song titles or current traffic news on the display.
56