Taurus HUBBLE ZOOM Manual De Instrucciones página 9

English
Multifunction Trimmer
HUBBLE ZOOM
DESCRIPTION
1 Appliance body
2 U blade
3 Precision trimmer
4 Nose/ear trimming head
5 On/Off button
6 Pilot lights
7 Fixed guide comb (1mm)
8 Sliding guide comb (2-10mm in 2mm steps)
9 Sliding guide comb for beard/hair (12-20mm
in 2mm steps)
10 Slide comb release button
11 USB charging port
12 USB power cord
13 Cleaning brush
14 Lubricating oil
15 Storage pouch
USE AND CARE:
- Fully extend the appliance's power cable before
each use.
- Do not use the appliance if its accessories are
not properly fitted.
- Do not use the appliance if its accessories
attached to it are defective. Replace them
immediately.
- Do not use the appliance if on/off switch not
works.
- If you use the appliance in a bathroom or simi-
lar place, unplug the appliance from the mains
when it is not in use, even if it is only for a short
while, as proximity to water involves a risk,
even if the appliance is disconnected.
- Disconnect the battery charger from the mains
when not in use, before undertaking any clea-
ning task make any adjustment or accessory
change.
- Store this appliance out of reach of children
and/or persons with physical, sensory or
reduced mental or lack of experience and
knowledge.
- Never rest the appliance into a surface while
in use.
- Keep the appliance in good condition. Check
that the moving parts are not misaligned or
jammed and make sure there are no broken
parts or anomalies that may prevent the
appliance from operating correctly.
- Pay special attention when assembling and
removing the accessories, as the blades are
sharp. Be careful and avoid direct contact with
the blades' cutting edges.
- Never leave the appliance connected and unat-
tended if is not in use. This saves energy and
prolongs the life of the appliance.
- Do not use the appliance with pets or animals.
- Do not open the battery/ies under any circum-
stances whatsoever.
- Recharge the battery only with the USB power
cord supplied by the manufacturer, any other
type of cable may cause explosion or fire ha-
zard. Do not use USB adapters.
- Use the device only with the battery/ies for
which has been specifically designed. The use
of any other battery/ies s can cause an explo-
sion or fire hazard.
CHARGING THE BATTERY:
- Caution: a new battery is not fully charged and
must therefore be charged before the applian-
ce is used for the first time.
- Charge the battery at an atmospheric tempera-
ture of between 4 and 40ºC.
- Connect the charger (12) to the jack using the
socket on the appliance. The socket is located
at the lower/back part of the appliance.
- Plug the charger (12) into the mains.
- The pilot light (6) will blink to indicate that the
charger is charging the battery.
- Approximately 100 minutes are needed for a
complete charger of the battery.
- When the battery is charged disconnect the
charger from the mains supply.
HOW TO CHECK THE BATTERY'S CHARGE
LEVEL:
- The load indicator (6) has 4 leds that will be set
as they reach 25%, 50%, 75% and 100% of the
battery level.