Milwaukee WCE 30 Instrucciones De Uso página 9

Advices for
operation
Tips
Service
Accessories
ENGLISH
Only use the machine for dry cutting in stone.
Mind hidden electric lines, gas and water pipes. Check your working area, e.g. with
a metal detector.
1. Pre-select the cutting depth and width.
2. Switch the machine on.
3. Set the machine with the front edge of the
cutting support touching the masonry and
lower it gently in until the cutting support lies
flush.
4. Cut the masonry groove by pulling the ma-
chine towards you (in direction of arrow in il-
lustration), guiding the machine with both
hands. Only cut straight lines radii are not
possible.
Always use the additional handle.
When cutting hard material, swing the ma-
chine slightly to and fro in the cut then the
diamond cutting discs stay sharper longer.
5. When you get to the end of the groove you
are cutting, lift the machine out first and then
switch off.
After switching off, the machine will not be
idle immediately. (After-running of the work
spindle.) Allow the machine to come to a stop before putting down.
The cutting discs get very hot when in use. Do not touch them before they have
cooled down.
6. Put the machine down and break out the remaining strip with the paring-out tool.
The infinitely variable cutting width adjustment has the advantage that if the cutting
width was set correctly, the pipes or similar fit the slot exactly. They do not have to
be additionally secured with nails etc. against falling out.
Cutting hard materials, especially concrete, requires a very high engine perform-
ance. If the feed rate is too high the load-rate motor protection slows the motor
down.
We recommend: When having to cut into the material very deeply, cut in two steps.
First, cut about half the required depth, and in a second step cut the full depth.
Blunt diamond cutting discs are recognisable by the large number of sparks that fly
during work, and can be resharpened by making a number of cuts in abrasive ma-
terial (e.g. plaster).
Keep the machine and the ventilation slots clean.
Use only Milwaukee accessories and spare parts. Should components which have
not been described need to be exchanged please contact one of our Milwaukee
service agents (see our list of guarantee/service addresses)
If needed, an exploded view of the tool can be ordered. Please state the ten-digit
No. as well as the machine type printed on the label and order the drawing at your
local service agents or directly at:
Atlas Copco Electric Tools GmbH, Postfach 320, D-71361 Winnenden.
Please refer to page 2 for range of accessories. Further accessories with part num-
bers are shown in our catalogues.
9 WCE 30