Milwaukee WCE 30 Instrucciones De Uso página 4

Measured
sound value
Measured
vibration value
Usage
Mains
connection
Electronics
Smooth start
ENGLISH
Pay attention to the dimensions of the cutting discs. The diameter of the centre hole
must fit the flange without play. Do not use any reduction pieces or adapters.
Only use the machine for dry cutting in stone.
Mind hidden electric lines, gas and water pipes. Check your working area, e.g. with
a metal detector.
Measured values determined according to EN 50 144.
Typically the A-weighted noise levels of the tool are:
Sound pressure level = 86 dB (A).
Sound power level =
Wear ear protectors!
Typically the hand-arm vibration is below 2.5 m/s
The wall-chaser machine cuts slots for cables and pipes (masonry grooves) in any
kind of brickwork with two diamond cutting discs running parallel to each other.
The infinitely variable cutting width adjustment has the advantage that if the cutting
width was set correctly, the pipes or similar fit the slot exactly. They do not have to
be additionally secured with nails etc. against falling out.
Do not use this product in any other way as stated for normal use.
Connect only to a single-phase AC current supply and only to the mains voltage
specified on the rating plate. Connection to sockets without earth protection is
possible as the appliance features protective insulation to DIN 57 740/ VDE 0740
and CEE 20. Radio suppression complies with the European standard EN 55014.
When fitting the plug, make sure that the brown (live) wire of this appliance is
connected to the plug terminal marked L or coloured red, and the blue (neutral) wire
of this appliance is connected to the plug terminal marked N or coloured black.
Under no circumstances must the wires of this appliance be connected to the earth
terminal of the plug marked either E, with the earth symbol, or coloured green or
green/yellow.
The speed of rotation is adjusted electronically when the load increases.
In case of a longer overload period the speed is decreased electronically. The ma-
chine continues to run slowly to cool down the motor coil. After switching off and on
the machine can be used at rated load.
The duration of cooling-down period depends on the grade of overload.
Under the effect of extreme electromagnetic interferences from the outside, tempo-
rary variations in the speed of rotation could arise in particular cases.
The electronic smooth start will prolong the life of both the motor and the gears.
Therefore do not run the machine under load for 2 sec. after switching on.
4
99 dB (A).
2
.
WCE 30