Descargar Imprimir esta página

EdilKamin BIJOUX Instalación Uso Y Mantenimiento página 48

Ocultar thumbs Ver también para BIJOUX:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 84
Environmental temperature control
this comfortable and simple adjustment feature, as standard in
based on the environmental temperature.
After activating the "Comfort Clima" function from the para-
meters menu (ask the technical assistance centre - TAC), press
select the desired mode from the display.
Modulate power mode
ture set by the user.
Comfort Clima mode
rature set by the user. You can also use the remote control as a
Setting the environmental temperature
In "Comfort Clima" mode, by pressing the +/- buttons on the
synoptic panel or on the remote control, you can set the display
to the desired environmental temperature.
-With environmental temperature reached (+2°C), the stove
The environmental temperature is transmitted from the remote
control; the remote control transmitter must be visually aligned
If the remote control is incorrectly positioned, it cannot send
its recorded temperature. The stove therefore independently
Temperature control with external thermostat
another temperature control system is available as an alterna-
tive to the remote control. You can in fact connect the thermo-
stat serial port to your home thermostat or any (clean output
contact) easily available one
reach the set temperature
-With environmental temperature reached by the thermostat
Temperature
provided by the
remote control
"Comfort
Clima"
ON
parameter
"SONDA IR"
ON
parameter
Connection to
NO
serial port
no connection
INSTRUCTIONS FOR USE
-
Temperature
provided by
No adjustment
(factory setting)
environmental
thermostat
ON
ON
OFF
ON
Yes
NO
no connection
serial cable
lator with electronic motor.
Electronic control of operation:
a) Control mode p – c
In this mode, the electronic controller keeps the differential
-
b) Control mode p – v
In this mode, the electronic controller varies the pressure
c) Venting procedure
hydraulic circuit. After manual selection of the "AIR" mode,
minimum speed for 10 minutes. At the end of the procedure,
the desired mode of operation
- 48
-
-

Publicidad

loading

Este manual también es adecuado para:

CameoStrassTresor