Publicidad
Idiomas disponibles
Idiomas disponibles
10. The rear surface of the oven also heats up when
the oven is operated. Electrical connections shall not
touch the rear surface, otherwise the connections may
be damaged.
11. Do not tighten the connecting cables to the oven
door and do not run them over hot surfaces. If the cord
melts, this may cause the oven to short circuit and
even a fire.
12. If the power supply cable is damaged, it must be
replaced by its manufacturer or authorized technical
service or any other personnel qualified at the same
level, in order to avoid any dangerous situation.
13. Do not use steam cleaners for cleaning the appliance,
otherwise electric shock may occur.
14. An omnipolar switch capable to disconnect power
supply is required for installation. Disconnection from
power supply shall be provided with a switch or an
integrated fuse installed on fixed power supply according
to building code.
15. Appliance is equipped with a type ''Y'' cord cable.
16. Fixed connections shall be connected to a power
supply enabling omnipolar disconnection. For appliances
with over voltage category below III, disconnection device
shall be connected to fixed power supply according to
wiring code.
11
Publicidad
