VITO PRO-POWER vikmf218a Manual De Instrucciones página 21

EN
SETUP &
PREPARATION
Changing Accessories:
Ensure the tool is disconnected
from the power supply before
performing any of the following
operations.
1) Press and hold the spindle lock
button.
2) Unscrew the collet nut. Remove
it completely.
3) Select a suitable collet for the
accessory to be used and insert
it. Cover it with the collet nut.
4) Slightly hand-tighten the collet
nut so that it stays in place.
5) Insert the shaft of the accessory
into the collet.
6) Tighten the collet nut using the
spindle lock and spanner.
7) Remove the screw from the end
of the disc holder.
8) Fit the fibre flange either side
of the cutting disc, then insert
the screw.
9) Tighten the cutting disc onto the
cutting disc holder.
NOTE: Do not over-tighten the
screw as it could result in damage
to the cutting disc.
21