Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always be followed
including the following:
Read All Instructions Before Use
•
Use iron only for its intended use.
•
To protect against risk of electric shock, do not immerse the iron in water or other
liquids.
•
The Steam Lever should always be turned to the dry
unplugging from outlet. Never yank cord to disconnect from outlet; instead, grasp plug
and pull to disconnect.
•
Do not allow cord to touch hot surfaces. Let iron cool completely before storing. Loop
cord loosely around iron when storing.
•
Always disconnect iron from electrical outlet when filling with water, cleaning,
emptying or when not in use.
•
Do not operate iron with a damaged cord or if the iron has been dropped or
damaged. To avoid the risk of electric shock, do not disassemble the iron. Take it to
an authorized service center for examination and/or repair. Incorrect reassembly can
cause a risk of electric shock when iron is used.
•
Close supervision is necessary for any appliance being used by or near children. Do
not leave iron unattended while plugged in, turned on or on an ironing board.
•
Burns can occur from contact with hot metal parts, hot water or steam. Use caution
when you turn a steam iron upside down – there may be hot water in the reservoir.
•
If the iron is not operating normally, disconnect from the power supply and have the
iron serviced by an authorized service center.
•
Your Oster
®
provided. Do not leave the iron unattended. Do not set the iron on an unprotected
surface, even if it is on the heel rest.
•
This is a high wattage appliance. To avoid a circuit overload, do not operate another
high wattage appliance on the same circuit.
•
If an extension cord is absolutely necessary, a cord with an ampere rating equal to
or greater than the maximum rating of the iron shall be used. Cords rated for less
amperage may overheat. Care should be taken to arrange the extension cord so that
it cannot be pulled or tripped over.
•
The iron must be used and rested on a flat, stable surface.
•
When placing iron on its stand, ensure that the surface on which the stand is placed
is stable. When not in use, place and lock the iron onto the charging base.
•
The iron is not to be used if it has been dropped, if there are visible signs of damage
or if it is leaking.
GCSTCC5000_22SEPM1 (LA).indd 1
GCSTCC5000_22SEPM1 (LA).indd 1
iron is designed to rest on the heel rest. Use only with the heel rest
setting before plugging or
English - 1
2022/9/14 10:35 AM
2022/9/14 10:35 AM
Publicidad
