Publicidad
Idiomas disponibles
Idiomas disponibles
Filling Water Reservoir (Use Tap Water)
1. Make sure the iron is unplugged.
2. Move steam lever to dry setting
3. Open the water fill hole cover by gripping the tab and gently pulling to open.
4. Use an easy-pour measuring cup to fill water reservoir with tap water through the
water fill hole. Do not fill water reservoir beyond the max line.
5. Close the water fill hole cover securely after filling.
WARNING: To prevent the risk of burns, be careful when filling a hot iron with water. Hot
metal parts, hot water and steam can cause injuries.
1. Ensure Steam Lever is moved to the Dry
the charging base on a flat, stable surface (follow instructions for "Corded Mode").
2. Set Fabric Select Dial according to fabric type (Figure 1).
NOTE: If not sure of the fabric type, it is best to first test the temperature of the iron on a
hem or an inside seam.
3. Plug the power cord into a standard household outlet of the same voltage as the one
indicated in the rating label of your iron.
• The red Indicator Light comes on to indicate iron is heating up.
• When the Indicator Light turns solid green, the iron has reached required temperature
and is ready for use.
4. To use the iron without the cord, follow instructions for "Cordless Mode."
NOTE: While the Steam Lever is turned to the Dry
OF STEAM or SPRAY MIST feature, as long as the Fabric Select Dial is set to wool,
cotton, or linen / high temperature. Make sure the water reservoir is approximately ¼ full
of water.
GCSTCC5000_22SEPM1 (LA).indd 6
GCSTCC5000_22SEPM1 (LA).indd 6
.
Dry Ironing
setting and iron is locked in position on
Figure 1
setting, you may still use the SHOT
English - 6
2022/9/14 10:35 AM
2022/9/14 10:35 AM
Publicidad
