Garland 1480 TQG Manual De Instrucciones página 39

5.4.2.2. COLD-STARTING THE ENGINE
A. Place the ON/OFF switch in the "ON" position.
B. Place the fuel tap in the open position.
C. Place the air lever in the Closed position
D. Place the accelerator lever in the maximum
position .
E. Pull the starter grip until the engine starts up and
go past the air lever slowly to the OPEN position
(normal working position). Put the throttle lever
in the down position and let the engine warm for
1 minute before starting to work.
Normal working
position
5.4.2.3. WARM ENGINE START
Follow the A & B steps on the Cold engine start. Move
the throttle to middle position and pull the starter grip
until it starts.
5.4.2.4. STOP THE ENGINE
Move the throttle lever to the down position and the
engine switch OFF. If you put the shredder away,
move the lever to the passage of gasoline in the OFF
on.
6. MACHINE USAGE
.
Only use this machine for those jobs for which it
has been designed. The use of this machine for other
uses is dangerous and could cause damages to the
user and/or the machine.
Place the branches in the entry chute and once they
are inside, let them go. The machine will suction
the branches automatically. When introducing wider
branches, ensure that the engine speed is sufficient.
Cut the side branches with a width of more than 3cm
from the main branch and introduce separately. Long
branches could hit you in the face and therefore you
must maintain a safety distance and always use a
face protector.
39/148
English
Throttle level