Publicidad
Idiomas disponibles
Idiomas disponibles
SET UP & USE
CONTROL PANEL
Timer
Indicator Light
Timer Button
Fan Speed
Selection Button
Pictures are for illustration purpose only. Your model may or may not have all the features.
OPERATING FROM THE CONTROL PANEL
The Control Panel enables you to manage all the main functions of the
appliance, but to fully exploit its potential, you must use the remote
control.
TURNING THE APPLIANCE ON
• Plug into the dedicated electrical outlet. Two lines appear on the display
indicating that the appliance is in standby. (Fig. 6)
• Press the
button until the appliance comes on. The last function active when
it was turned off will appear.
* Never turn the air conditioner off by unplugging from the outlet. Always press
the button
, then wait for a few minutes before unplugging. This allows the
appliance to perform a cycle of checks to verify operation.
Note: Before pressing Power On button make sure the condensate drain plug in
the rear of the unit is securely in place to avoid any leaking.
• Press the MODE button until the light corresponding to the required Mode
lights up.
COOL
DEHUMIDIFY
Display Area
Fan Speed
Indicator Light
Decrease
Temp/Time
Button
HEAT
FAN
(Heat model
BPT10HWTB only)
Selected Mode
Indicator Light
Increase
Temp/Time
Selection Button
Button
Sleep
Indicator Light
ON/OFF
Mode
Fig. 6
SMART
Page 15
Publicidad
