Airzone acuazone innobus PRO 32 Manual De Usuario página 42

6) End time: Select by using
program to end simply press on
7) End status: Select the final action for the program. Same options as Initial status are
available.
8) Summarize: Check your time program edition with this screen. If you wish to modify any
previously set parameter, press
Finally, press
Once the program is stored, it will be listed on the time programs stored and will
be, by default, activated.
3.7.3 EDIT, DEACTIVATION OR ERASE A TIME PROGRAM.
There are various actions that can be done upon stored time programs.
On the main scree, press
Select the program you want to modify and then press on
• Edit: Allows modifying of any set parameter. Process is similar to time programming creation
(see point 3.7.2)
• Stand-By: This option deactivates the time progra so that it will not comes in to action. To
do so, select Stand-by and press
pressing . Any unactive time program will be listed with a grey icon beside it.
To activate it again do as before but selecting "Activate".
• Delete: If you want to delete any time program, pres son "Delete" and press on
confirmation message will be prompted; confirm by pressing
If at any time during time programming you may wish to quit without saving, press on
3.8 REMOTE ZONE ACCESS
From the Remote zone access of the Blueface you can control any or all other thermostat
present in the system. You can enter this menu by pressing the zone label
Blueface main screen (see Fig. 1) or enter menu and press "Remote zones" and do as follow:
1. Either select the zone you wish to modify or every zone
2. Upon selection Blueface leads you to remote zone screen.
3. Modify parameter you wish to set and press on confirmation icon
back to the "User settings" submenu and cancel selection by pressing on the
back main screen by pressing on the
On/Off status
Zone set-point temperature (if remote zone set to Off, it is set to On).
Fan coil fan speed (only for Fancoil installations).
Activate or deactivate time programming.
Time programming (only for single zone remote access)
(every day, weekends, labour days or individual days) by pressing the desired option
and confirming by pressing
Prog. 2 or Prog. 3) an confirm by pressing
42
icons and press
.
and modify.
to store the time program edited.
and the press Programming.
. A confirmation message will be prompted; confirm by
icon.
icon. Next, select memory where to store (Prog. 1,
to confirm. If you do not want your
. Available actions are:
.
.
. You can also go
: Select days group
icon. See 3.7.2.
. A
.
on
icon or go