Joie steadi Manual De Instrucciones página 9

Installation for
Rearward Facing Mode
(for Child under 18kg / New born - 4 years old)
see images
-
8 20
Reference age New born - 4 years old
Seat position Last position (with top blue artwork align with bottom
reclining position indicator, as
!
Please install the child restraint on the vehicle seat, and then put the child in
the child restraint.
i. Proper Position of the Shoulder Harnesses
Please adjust the head support and shoulder harnesses to proper height
according to the child's height.
!
The shoulder harness slots should be slightly below the infant's
shoulder. Shoulder harnesses too high or too low are not safe.
!
If the shoulder harnesses are not at proper height, the infant may be
thrown from the child restraint when there is an accident.
ii. Use of Small Seat Pad
see images
-
9
13
1. While pulling up on the webbing adjuster, pull out the shoulder harness
straps to proper length.
2. Press the red button to disengage the buckle
fant body support in the child restraint.
3. Engage the buckle until it clicks.
4. Pull the adjustment webbing tight.
5
)
8
-1, and then place the in-
10
11
13
Note
1. Small seat pad include head support and inner cushions.
2. Head support is suitable for child in all installation modes.
3. Small seat pad is for child's protection. Child weighing under 9kg must
use small seat pad.
4. After removing the foam from the small seat pad, please store it in a
place where the child cannot access it.
5. Before using the small seat pad, please assemble the foam.
!
While pulling up the webbing adjuster, pull out the shoulder harnesses
to proper length.
12
iii. Rearward Reclining Angle Adjustment
see images
14
While pushing the reclining adjustment handle
straint from the first position to the last position.
Angle indication: with top blue artwork align with bottom reclining position
indicator, as
8
iv. Rearward Facing Installation
see images
-
15
18
Note
1. Make sure the shoulder harness is adjusted to proper height before
installing this child restraint.
2. First adjust the angle of the child restraint to the last position. Angle
indication: with top blue artwork align with bottom reclining position
indicator, as
8
3. When installing and adjusting the safety belts, make sure that both the
shoulder belt and the waist belt are not twisted and will not stop the
safety belts from functioning properly.
!
The child restraint can not be used if the vehicle safety belt buckle
(female buckle end) is too long to anchor the child restraint securely.
-1
15
9
-1, pull the child re-
14
-2
14
6