Roger Technology H85/TDS Instrucciones Y Advertencias Para El Instalador página 19

4
Functionality of the H85/TDS keypad
The H85/TDS code keypad consists of 12 keys, 4 of which also have a command activation function, to manage entry
using a code.
It has two indicator LEDs, one green LV and one red LR, and a buzzer.
Up to 500 user codes can be stored, each of which must have a minimum of 3 digits and a maximum of 6.
User codes are stored in the interface.
The keypad is backlit with white LEDs, which are brighter when the keys are pressed.
5
Functionality of the H85/DEC - H85/DEC2 interface
The H85/DEC interface connected to ROGER control units can handle up to a maximum of 4 H85/TDS keypads, while
the H85/DEC2 interface can handle a maximum of 2 H85/TDS keypads.
H85/TTD series touch keypads can be linked, provided that the total number of keypads linked is within the limits
6
Keypad installation
Depending on the type of keypad selected (see
• Undo the securing screws and open the H85/TDS keypad.
• Fix the keypad to the desired surface with suitable screws (not supplied).
• Make the electrical connections as shown in
use 0.5 mm 2 cable up to a maximum length of 100 m.
• Reassemble the H85/TDS keypad and fasten the side covers, ensuring they are positioned correctly.
7
Programming sequence
1) Store a user code; make a note of its value as it may be used to reset the password in the future (you must know
one of the user codes in the memory).
2) With LV and LR LEDs off (keypad in stand-by) check that the user code has been successfully stored by entering
the activation sequence and checking relay activation on the interface, knowing that keys 1/A, 3/B, 7/C, */D
4) Save a new password (factory default is 0000), note its value.
NOTE: changing the password is recommended to ensure the security of the installation.
8
Description of the H85/DEC - H85/DEC2 interface contacts
CONTACT
1(0V) 2(12/24)
3(ENA) 5(COM)
4(SYNC) 5(COM)
8 OUT A 9
10 OUT B 11
12 OUT C 13
14 OUT D 15
16 ALRM 17
24VAC-DC or 12VDC power supply.
Select the power supply type with the jumper J1 (see
A timer or a key contact can be connected between terminals 3-5.
The function is only active if the jumper J2 inset E is in the EXT position.
If the contact is open and a valid user code is entered on the keypad, the OUT relay can not be
activated.
Connecting the keypads to the power supply.
SYNC: Terminal for connecting multiple keypads with synchronising function.
Command output A (relay contact N.A.), can be activated with the 1/A button.
Command output B (relay contact N.A.), can be activated with the 4/B button.
Command output C (relay contact N.A.), can be activated with the 7/C button.
Command output D (Relay contact N.A.), can be activated with the */D button.
ALARM output (contact N.C.)
The contact opens when it detects an alarm state.
5, inset F).
), proceed with the installation as shown below:
. To connect to the H85/DEC or H85/DEC2 interface card,
H85/DEC
, inset D).
To exclude this function, see jumper J3 (
19