Num'axes CANICALM Manual De Instrucciones página 11

Ocultar thumbs Ver también para CANICALM:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Start of Service
CANICALM is supplied with battery fi tted.
Lift the n° 2 setting mask (Fig. 1) and turn the On/Off switch to On. After a few seconds, a beep
sound of 1.5 seconds will be emitted indicating that the collar is operating correctly.
Adjustment and positioning of the collar
The strap must be adjusted so that the contact points are in contact with the skin of the dog.
Collar adjustment is very important:
- If the strap is too loose, the collar is likely to move and repeated friction can irritate the skin of
your dog. Furthermore, it will not function correctly.
- If the collar is too tight, the dog will have breathing diffi culties.
Place the collar at the centre of the dog's neck.
Do not leave the collar more than 8 hours a day on your dog. Take the time to check that
there are no signs of irritation on your dog's neck.
Choice of contact points
Two different series of contact points are supplied. The length of the contact points must be
suffi cient to have proper contact with the dog's skin, enabling the device to operate correctly.
If you have a long haired dog and the short contact points fi tted to the collar in the factory
are inadequate, remove and replace them with the long ones supplied in the kit. A moderate
manual screwing is suffi cient (do not use any key).
Operation
At the fi rst bark, a series of six sound beeps is emitted. If another bark is detected within 30 sec,
another sound beep of 2 sec is emitted together with a stimulation (short or long as selected)
(Fig. 2). Inhibition of any further stimulations is dependant on the absence of any barking within
the next 30 seconds. The stimulation function can be inhibited using the stimulations switch
placed under the setting mask n° 1 (Fig. 2). In this case, only the beep sound will be emitted.
The barking detection sensitivity setting is a very important preliminary operation (Fig. 2). In
fact this setting determines the correct operation of the product. It provides sure detection of
any barking and helps avoid un-necessary detection. The setting must therefore be suffi ciently
sensitive but not too much.
11
11
GB
GB

Publicidad

Tabla de contenido
loading

Tabla de contenido