Num'axes CANICALM Manual De Instrucciones página 12

Fig. 1
Screwdriver
Checking the device operates correctly
Before doing so, make sure the collar is turned Off. Fix each wire of the neon test lamp under
each contact point (unscrewing them lightly and then retightening them so as to pinch the
test lamp wires). Position the stimulations switch on short or long stimulation then switch On the
collar. Make a streaked object slide over the bark detection contact point (e.g. sleeve isolated
knife with teeth). The test lamp will light indicating the collar is operating correctly.
GB GB
stimulation
inhibition
(beep sounds only)
Stimulations
switch
On/Off
switch
Regulating screw for bark detection sensitivity.
The system does not practically detect any
barking once the screw is tightened to the end
in the opposite way of a watch pointers.
12 12
Fig. 2
short
stimulations
long
stimulations
bark
detection
contact
point
Off
On