Dirt Devil UD70182 Manual De Instrucciones página 3

EXTENSION WAND: Attach to cleaning wand for
longer reach on above and hard fl oor cleaning.
*
TURBO TOOL : For upholstered furniture,
®
draperies, mattresses and stairs.
*Accessories not included on all models.
ABOVE FLOOR CLEANING
CAUTION:
Use extra care when
cleaning on stairs. To avoid personal injury or
damage, and to prevent the cleaner from falling,
always place cleaner at bottom of stairs or on
fl oor. Do not place cleaner on stairs or furniture,
as it may result in injury or damage. When
using tools, always ensure handle is in upright
position.
1
Remove Quick Release Cleaning Handle Wand for
convenient above fl oor cleaning.
2
Insert hose into handle wand.
3
Attach extension wand and 2-in-1 tool for
improved cleaning.
*Accessories not included on all models.
HOW TO
WARNING:
To reduce the risk of
personal injury - Unplug before cleaning or
servicing. Do not use vacuum without dirt cup
or fi lters in place.
This product contains no serviceable parts.
If appliance is not working as it should, has been
dropped, damaged, left outdoors, or dropped into
water, call customer service at
1-800-321-1134 prior to continuing use.
EMPTY THE DIRT CUP
A
1
Push the release button (A) then pull out the dirt
cup.
B
2
Now ditch the dirt by pushing the lower button
(B). Give it a wipe to remove dust.
3
Place back in bottom fi rst. Push the top of the cup
against the back panel, and it'll click into place.
CLEAN THE RINSABLE FILTER AND
CYCLONIC ASSEMBLY
WARNING:
To reduce the risk of
personal injury - Unplug before cleaning or
servicing. Do not use vacuum without dirt cup or
fi lters in place.
1
Remove the dirt cup. Twist the handle to remove
the top from the dirt cup. Gently remove the fi lter
from the handle.
CLEAN THE RINSABLE FILTER AND
CYCLONIC ASSEMBLY (CONT'D)
2
Tap clean into a trashcan.
3
All pieces are rinsable. Allow to dry 24 hours
before using.
4
Next pull cyclonic assembly out of the dirt cup.
5
Use the Dusting Tool to clean the cyclonic
assembly.*
6
When reassembling, ensure the cyclonic
assembly is aligned and twist the lid into the
locked position.
CLEAN THE EXHAUST FILTER*
1
Push the tab on the front of the cover to pivot out.
2
Pull out the fi lter, rinse dirt from both sides, and let
air dry for 24 hours before reinstalling or until dry.
3
Put the dry fi lter back. Now line up the fi lter cover
with the bottom tabs fi rst and then snap back
into place.
*Not all models have this feature
CLEAN THE BRUSHROLL
1
Turn your vacuum over. Use a Phillips screwdriver
to take off the 6 screws. Remove the bottom
plate.
2
Clean the brushroll.
3
Slide on belt with the lettering on the outside.
REPLACE THE BELT
CAUTION:
To reduce the risk of injury
from moving parts - Unplug before servicing.
1
Turn your vacuum over. Use a Phillips screwdriver
to take off the 6 screws. Remove the bottom
plate.
2
Then take off that old belt. Slide on a new belt
with the lettering on the outside.