Publicidad
Idiomas disponibles
Idiomas disponibles
Spillovers on the
1.
touch controls.
2.
3.
4.
5.
Hints and Tips
The table shows possible problems that can be corrected according to the instructions
listed below.
Problem
The cooktop cannot be
turned on.
The touch controls are
unresponsive.
The touch controls are
difficult to operate.
The glass is being
scratched.
Some pans make
crackling or clicking
noises.
Switch the power to the
cooktop off.
Soak up the spill.
Wipe the touch control
area with a clean damp
sponge or cloth.
Wipe the area completely
dry with a paper towel.
Switch the power to the
cooktop backon.
Possible causes
No power.
The controls are locked
There may be a slight film
of water over the controls
or you may be using the
tip of your finger when
touching the controls.
Rough-edged cookware.
Unsuitable,abrasive
scourer or cleaning
products being used.
This may be caused by
the construction of your
cookware (layers of
different metals with
brating differently).
• The cooktop may beep and turn itself off, and the touch
controls may not function while there is liquid on them.
Make sure you wipe the touch control area dry before
turning the cooktop backon.
What to do
Make sure the induction hob is connected to the power
supply and that it is switched on.
Check whether there is a power outage in your home or
area.If you've checked everything and the problem
persists,call a qualified technician.
Unlock the controls.See section 'Using your induction
cooktop' for instructions.
Make sure the touch control area is dry and use the ball
of your finger when touching the controls.
Use cookware with flat and smooth bases.See 'Choosing
the right cookware'.See'Care and cleaning'.
This is normal for cookware and does not indicate a fault.
58
Publicidad
