Jocel JPIC007476 Manual De Instrucciones página 63

Connecting the hob to the mains power supply
The power supply should be connected in compliance with the relevant standard, or a single-
pole circuit breaker. The method of connection is shown below.
1. If the cable is damaged or needs replacing, this should be done
by an after-sales technician using the proper tools, so as to avoid
any accidents.
2. If the appliance is being connected directly to the mains supply,
an omnipolar circuit breaker must be installed with a minimum
gap of 3mm between the contacts.
3. The installer must ensure that the correct electrical connection
has been made and that it complies with safety regulations.
4. The cable must not be bent or compressed.
5. The cable must be checked regularly and only replaced by a
properly qualified person.
6. The installer must to use the H05GG-F power cord.
ELIMINATION: Do not dispose this product as unsorted municipal waste.
Collection of such waste separately for special treatment is necessary.
This appliance is labeled in compliance with European directive 2002/96/EC for Waste
Electrical and Electronic Equipment (WEEE). By ensuring that this appliance is disposed of
correctly, you will help prevent any possible damage to the environment and to human health,
which might otherwise be caused if it were disposed of in the wrong way.
The symbol on the product indicates that it may not be treated as normal household waste. It
should be taken to a collection point for the recycling of electrical and electronic goods.
This appliance requires specialist waste disposal. For further information regarding the
treatment, recovers and recycling of this product please contact your local council, your
household waste disposal service, or the shop where you purchased it.
For more detailed information about treatment, recovery and recycling of this product, please
contact your local city office, your household waste disposal service or the shop where you
purchased the product.
62
400 V 3~
16A
L1 L
L2
220-240
V~
N