Adjusting The Nailing Depth; Using The Nose Cap - Metabo HPT NP 35A Instrucciones Y Manual De Seguridad

3 Pull the trigger.
1
3

ADJUSTING THE NAILING DEPTH

● When adjusting the nose, be sure to remove
your fi nger from the trigger and lock lever,
and disconnect the air hose from the Nailer.
To assure that each nail penetrates to the same depth, be
sure that:
1) the air pressure to the Nailer remains constant
(regulator is installed and working properly), and
2) the Nailer is always held fi rmly against the workpiece.
If nails are driven too deep or shallow into the workpiece,
adjust the nailing in the following order.
1 Disconnect air hose from Nailer.
Screw
Nose
Screw
2 To adjust the driven-in depth of a nail, loosen the
screw that secures a nose.
If the nail is driven in deeply, adjust the nose to "up",
and if it's driven in shallowly, adjust the nose to
"down".
2
WARNING
14
Disconnect air
hose
Too deep
Too shallow
3 Tighten the screw to fasten the nose when a suitable
position is reached for a nailing test.
4 Connect the air hose.
Always wear eye protector.
Perform a nailing test.
5 Disconnect air hose from Nailer.
6 Choose a suitable position for the nose.

USING THE NOSE CAP

● When attaching or detaching the nose cap,
be sure to remove your fi nger from the
trigger and lock lever, and disconnect the air
hose from the Nailer.
If you like to protect the surface of workpiece against
scratches or markings made by the nose, attach the
accessory nose cap to the nose.
1 Disconnect air hose from Nailer.
2 Attach the nose cap to the nose with the arrow mark
on the cap facing toward the front.
3 When not using the nose cap, secure in the storage
compartment located on the reverse side of the
magazine.
NOTE
The nose cap may reduce nailing depth due to its
thickness. Re-adjustment of nailing depth is required.
English
WARNING
15