Hansgrohe PuraVida 15446 1 Serie Instrucciones De Montaje página 2

English
Technical Information
Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Flow rate - spout
Flow rate - handshower
15456XX1
15446XX1
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
Installation Considerations
• For best results, Hansgrohe recommends that this unit
be installed by a licensed, professional plumber.
• Please read over these instructions thoroughly before
beginning installation. Make sure that you have all
tools and supplies needed to complete the installation.
This trim kit requires rough valve
06646000 (not included).
• This unit is not anti-scald.
required by local plumbing code, install an approved
water temperature limiting device conforming to ASSE
1070 (not available from Hansgrohe).
• The finished mounting surface must be complete and
made watertight before installation of this trim.
• 15456XX1 only: This handshower is for use with
automatic compensating valves rated at 1.3 GPM
(4.9 L/min) or less.
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (48° - 60° C)*
158°F (70° C)*
6.6 GPM (25 L/min)
max. 1.75 GPM (6.6 L/min)
max. 2.0 GPM (7.6 L/min)
In Massachusetts, or if
• 15446XX1 only: This handshower is for use with
automatic compensating valves rated at 1.5 GPM
(5.7 L/min) or less.
• Protection against backflow is provided by a check
valve in the handshower elbow and by an automatically
resetting diverter.
• To prevent scald injury, the maximum output temperature
of the shower mixing valve (not included) must be no
higher than 120°F (49°C). In Massachusetts, the
maximum output temperature can be no higher than
112°F (44°C).
• Keep this booklet and the receipt (or other proof of
date and place of purchase) for this product in a safe
place. The receipt is required should it be necessary to
request warranty parts.