Publicidad
Idiomas disponibles
Idiomas disponibles
ATTACH REAR WHEELS (MODEL 1)
Drive wheel
10
10
×
Turn vehicle body upside down.
×
Remove all parts from the rear axle.
1.
Slide the gearbox on the rear axle from the left side (gearbox with the "R" label must fit on the "R" side,
gearbox with the "L" label must fit on the "L" side), keep the connector and gearbox motor through
the larger hole and out of the battery location.
2.
Slide the drive wheel over the rear axle. Keep it at the height of the gearbox.
3.
Slide a Ø12 washer onto the rear axle.
4.
Tighten the lock nut on the rear axle end with a wrench.
5.
Slide the Ø12 washer onto the rear axle (right side).
6.
Insert the bushing into the hole in the center of the normal wheel.
7.
Slide the normal wheel over the rear axle.
8.
Slide the Ø12 washer onto the rear axle.
9.
Tighten the locknut at the rear axle end with a wrench.
TIP: An additional wrench has been provided to hold the lock nut on the other side of the rear
axle while tightening the lock nut on the other side.
10.
Mount the hubcaps on the wheels.
3
3
4
4
5
5
6
6
2
2
7
7
8
8
65
1
1
Rear axle
Normal wheel
9
9
10
10
EN
Publicidad
