Publicidad
Idiomas disponibles
Idiomas disponibles
FIX REAR WHEELS (MODEL 2)
1.
Slide the gearbox onto the rear axle (the gearbox with the "R" label must be fitted to the "R" side of
the body; the gearbox with the "L" label must be fitted to the "L" side of the body). Keep the engine
and gearbox connector through the larger hole at the rear of the vehicle and out of the battery
location.
2.
Slide the drive wheel over the rear axle. And keep the drive wheel at the height of the gearbox.
3.
Slide the Ø12 washer onto the rear axle.
4.
Tighten the locknut at the rear axle end with a wrench.
TIP: An additional wrench has been provided to hold the lock nut on the other side of the rear axle
while tightening the lock nut on the other side.
Repeat the above procedure to mount the other drive wheel.
5.
Mount the hubcaps on the wheels.
FIX THE FRONT WHEELS
×
Remove all parts from the front axle.
1.
Slide the Ø12 washer onto the front axle.
2.
Slide a sleeve over the front axle.
3.
Slide a normal wheel over the front axle. Make sure the hub matches the drive wheel.
4.
Slide a Ø12 washer onto the front axle.
5.
Tighten the locknut at the end of the front axle with a wrench.
6.
Fit the hubcap to the wheel
×
Repeat the above procedure to mount the other normal wheel.
Driving wheel
Drive wheel
3
3
4
4
5
5
Normal Wheel
4
6
5
66
1
1
2
2
Front axle
1
2
3
Rear axle
Rear axle
Publicidad
