Installation
Wall mounting
Installation on a stratification
cylinder
Threaded sleeves
3064926_202207
Freshwater module installation instruc-
tions
Positioning and installation may only be carried out by an authorised contractor.
The system must be installed in a location that is protected from frost.
When installing the FWS-2-60 freshwater module on a cylinder, and when in-
stalling BSP-MK circuits with mixers at the same time, these circuits must be
installed and connected to the pipework first.
Use the mounting hardware supplied with the system (2 x M10 x 100 threaded
studs + 6 x M10 nuts + 4 x M10 washers) to install it on a stratification cylinder.
After installing the buffer cylinder insulation, turn the threaded studs about
10mm into the threaded sleeves located on the cylinder.
Use the corrugated pipe cylinder connection set, a secure and time-saving
connection, for installing the system on stratification cylinders.
53