Wolf FWS-2-60 Instrucciones De Montaje página 57

Freshwater module with fitted
DHW circulation module
ZP-3 DHW circulation module
3064926_202207
Installing the ZP-3 DHW circulation mo-
dule
DHW circulation line
DHW circulation module
fitted to freshwater module
Please note:
When installing the DHW circulation pump unit, avoid applying any tightening
torque or forces to pre-fitted components and connection points of the module.
The freshwater module is equipped for retrofitting a DHW circulation pump. The
ZP-3 DHW circulation module (accessory) consists of a pump with a module
connection (push-in design), a ball valve, and an offset fitting.
To install the ZP-3, extract the dummy cap split pin on the FWS-2-60 and re-
move the dummy cap. Insert the ZP-3 as far as it will go and secure it using
the split pin.
For cases where DHW circulation pumps are already installed on site, DHW
circulation can be implemented via the cold water connection.
57