MSW Motor Technics MSW-HT1 Manual De Instrucciones página 15

1. Press the locking pin.
2. Open the tacker.
3. Replace any missing staples. Close the device.
CAUTION! When clamping both arms of the tacker, be careful with your
fingers! Do not clamp the arms where the staples come out!
4. Every time the tacker hits a surface, it guarantees that the surface is stitched
to the material.
STAPLE REMOVER
The appropriately shaped device acts as a lever. A slight up-and-down motion is all it
takes to pull out the unwanted staple.
To remove a staple from a given surface:
1. place it between the jaws of the stapler,
2. press the device down.