Brandt BPV2423B Manual De Instrucciones página 11

EN
1 The hot plate must be selected.
2 Select power 9 and then press
power touch key
the touch key you must lower the
continuous cooking power to the
the automatic cook function starts
power level on the display.
SWITCHING THE AUTOMATIC
COOK START FUNCTION OFF
After at least 10 seconds have elapsed
since the beginning of the automatic
cook start function:
1 The hot plate must be selected.
2 Press touch key
indicator reaches level 9 and the
automatic cook start function will be
deactivated.
Timer Function
This function makes it easier to cook,
as you do not need to be present
throughout the process: the timed hot
after the set time has lapsed. There is a
separate timer for each hot plate, which
allows all of the hot plates to be timed
simultaneously.
With these models you can use the
clock as a timer for the hotplates for
times ranging from 1 to 99 minutes. All
the cooking areas can be programmed
individually and in a simultaneous
manner.
TIMING ONE HOTPLATE
1 The cooking zone to be timed must
be selected.
2 Select a power level for the hotplate
from 1 to 9 using the touch keys
or
3 Press clock touch key
Depending on the model,the
timed
during the time set.
8
4 Immediately afterwards, enter a
cooking time between 1 and 99
minutes, by using the touch keys or
time automatically. The respective
Or, when the countdown starts, the
relevant power level and
of the relevant heater area.
When the clock reaches 01, it will
switch from counting down minutes
to seconds.
Once the selected cooking time has
elapsed, the heating zone being timed
of beeps for several seconds. The
00 beside the hotplate that has been
disconnected.
If you wish to time another hotplate at
the same time, repeat steps 3 and 4.
indicator displays an H or otherwise an
any sensor.
CHANGING THE PROGRAMMED
TIME
To change the progrmmed time, you
must press the touch key of the timed
clock
change the time.
DISCONNECTION OF THE TIMER
If you want to stop the timer before the
programmed time is up
1 First select the hotplate and then
press clock touch key
2 Use the touch key
the time to 00. The clock is cancelled.
Alternative method :
After zone selection if
key is pressed for two seconds, the
related timer will be cancelled.
If due to an error one or several hot
will be automatically disconnected after
Table 2
Selected
power
level
1
2
3
4
5
6
7
8
9
has been triggered, a 0 is displayed if
the glass surface temperature is not
dangerous for the user or an H if there
is a burn risk.
To reconnect the appliance, switch it
then switch it on again.
Keep the control panel of the
heating areas clean and dry at all times.
In case of operating problems
or incidents not mentioned in this
manual, disconnect the appliance
and contact the BRANDT technical
service.
Recommendation for the
good use of vitroceramic
* Use pots or pans with thick,
* Pans with a smaller diameter than
the shown heating area are not
recommended.
* Do not slide pots and pans over the
glass as they may scratch it.
timer touch
* Although the glass can withstand
knocks from large pots and pans
without sharp edges, try not to
knock it.
* To prevent damage to the ceramic
MAXIMUM OPERATION
TIME
(in hours)
10
5
5
4
3
2
2
2
1
hobs