Publicidad
Idiomas disponibles
Idiomas disponibles
glass induction surface, try not to
slide the pots and pans over the
glass, and keep the bottoms of the
vessels
clean
and
condition.
Try not to spill sugar or
products containing sugar on the
glass while the surface is hot as
these could damage it.
Cleaning and maintenance
To keep the appliance in good
condition, clean it using suitable
products and implements once it has
cooled down. This will make the job
easier and avoid the build-up of dirt
Never use harsh cleaning products or
tools that could scratch the surface, or
steam-operated equipment.
A pot or pan may become
stuck to the glass due to a product
having melted between them. Do
not try to lift the pot while the hot
glass break.
Do not step on the glass or
lean on it as it could break and
cause injury. Do not use the glass
as a surface for putting objects.
BRANDT reserves the right to make
changes to its manuals that it deems
the product's essential features.
Environmental
considerations
The symbol
on the product
or its packaging means that this
product cannot be treated like
ordinary household waste.This
product must be taken to a recycling
collection point for electrical and
electronic appliances. By ensuring
that this product is disposed of
correctly, you will avoid harming
the environment and public health,
which could happen if this product
is not handled properly. For more
detailed information about recycling
this product, please contact your
local authority, household waste
service or the store where you
purchased the product.
in
good
The packaging materials used are
environmentally-friendly and can
be recycled completely. Plastic
components are marked >PE<, LD<,
>EPS<, etc. Dispose packaging
materials, like household waste, in
your local container.
If something does not work
Before calling the technical service,
perform the verifications specified
below.
The appliance does not work:
Ensure that the power cable is plugged
in.
The pot sticks to the glass:
If there is molten material between
the pot and the glass, set the hot
plate to maximum power and try to
separate them.
Single Sensor Error :
If any of the sensors is active more
than 10 seconds, this error situation
occurs and error code"F1" is showed.
roots. One of them is that there may
of the sensor.
Make sure that there is no any object
on the control unit, hob glass is wiped
with a dry cloth. If error situation
continue after this solution, please
for 10 second.
Plural Sensor Error:
If more than 2 sensors are sensed at
same time, this error situation occurs
and error code"F2" is displayed.
Potential root reasons of the
problem :
sensors
• Touch control location may
exposure more heat or steam
Please be sure that there is no any
all steam and heat sources.
switch for 10 second.
FC Error:
Fc message on the control and the
hot plates switch off: Overheating
in the electronics. Let thestove cool
for a while.
EN
9
Publicidad
