Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaning planning
1.
Arrange long runs with a minimum of stopping or starting.
2.
Allow a small amount of broom path overlap to ensure complete coverage.
3.
Avoid making sharp turns, bumping or scraping the side of the machine.
Filling the DustGuard™ system water tank (optional)
1.
2.
STARTING AND STOPPING THE MACHINE
Starting the machine
1.
Sit on the driver's seat (3) and adjust it with the lever (4) to allow easy reach of all controls.
NOTE
on the driver's seat.
2.
Insert the ignition key (61) and turn it clockwise to "II", then release it. Wait (a few seconds) for the display (69) to turn on and
sowing the working hours.
CAUTION!
When starting do not press the drive pedal (5).
3.
Check that the green battery warning light (71) is on. If the yellow or red warning light (72 or 73) turns on, turn the ignition key
to "0" and remove it. Charge the batteries (see the procedure in Maintenance chapter in the User Manual).
4.
Disengage the parking brake.
5.
Drive the machine to the working area, by keeping the hands on the steering wheel (1) and pressing the pedal (5).
The drive speed can be adjusted from zero to maximum speed by increasing the pressure on the pedal.
7.
The forward/reverse direction is selected with the relevant switch (68) on the dashboard. When the reverse gear is selected,
the relevant buzzer turns on.
8.
Lower the main broom with the lever (63).
9.
Lower the side brooms with the lever (64).
NOTE
10. Start sweeping by driving the machine with the hands on the steering wheel (1) and by pressing the drive pedal (5).
NOTE
WARNING!
When steering, avoid abrupt direction changes, pay careful attention and drive the machine at slow speed,
especially when the hopper is full or when operating on inclines.
Drive the machine slowly on inclines. Use the brake pedal (6) to control machine speed while descending
inclines.
Do not turn the machine on an incline; drive straight up or down.
Stopping the machine
1.
To stop the machine, release the drive pedal (5).
2.
To stop the machine quickly, also press the service brake pedal (6).
WARNING!
Frequent and extended use of the service brake (6), especially on slopes, can cause a rapid wear of the pads.
Maintenance Table in Maintenance chapter in the User Manual).
3.
In case of emergency, press the emergency push-button (79) to immediately stop the machine.
To deactivate the emergency push-button (79), turn it clockwise.
4.
Turn the ignition key (61) to "0" and remove it.
QUICK START GUIDE
1464807000 - SW4000
ENGLISH
33
Publicidad
