Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
installing attachments or accessories. An accidental
start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. C, D)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in the
tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button
and firmly pull the battery pack out of the tool
8
handle. Insert it into the charger as described in the charger
section of this manual.
Fig. C
Fig. D
Proper Hand Position (Fig. E)
WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal injury,
ALWAYS hold securely in anticipation of a sudden
reaction.
Proper hand position requires one hand on the main handle
1
as shown in figure E.
Fig. E
8
7
into the tool handle, align the
7
8
On/Off Switch
•
To switch the tool on, depress the on/off switch
"I" position.
•
To switch the tool off, depress the on/off switch
the"O" position.
Operation
WARNING: Let the tool work at its own pace. Do
not overload.
Grasp the sander and turn it ON. Move it in long, sweeping
strokes along the surface, letting it do the work. Pushing
down on the tool while sanding actually slows the removal
rate and produces an inferior quality finish.
Check your work often. This sander is capable of removing
material rapidly.
Dust Collection (Fig. F, G)
WARNING: Collected sanding dust from sanding
surface coatings (polyurethane, linseed oil, etc.)
can selfignite in sander dust bag or elsewhere
and cause fire. To reduce risk, empty bag frequently
and strictly follow sander manual and coating
manufacturer's instructions.
•
The dust bag should be emptied after every 10 minutes
of sanding.
•
Slide the dust bag onto the dust port and make sure that
it is securely attached as shown in Figure F.
•
To remove the dust bag, pull it off and away from the
back of the tool.
•
To empty the dust bag, remove it from the dust port
and dump the sanding debris into an appropriate trash
receptacle Figure G.
Fig. F
Fig. G
2
2
4
5
at the
at
Publicidad
Tabla de contenido
