Publicidad
Idiomas disponibles
Idiomas disponibles
GB
10.1 Preparation
▶
Take t he appliance out of t he packaging.
▶
Remove all packaging material including polystyrene base, keep t hem out of childrens
reach. While opening t he package, water drops may be seen on plast ic bag and port-
hole. This normal phenomenon result s from water test s in t he factory.
Note: Packaging disposal
Keep all packaging materials out of children´s reach and dispose t hem in an environmen-
t ally friendly manner.
10.2
Noise resuction pads installation instructions
1.
reduct ion pads.
These are used for reducing noise. (Fig. 10- 1)
2. Lay t he washing machine down to it s side, port hole
point ing upwards, bottom side towards operator.
3.
double- sided adhesive prot
ct ion pads under t he washing machine cabinet as sh-
own in Figure 10.1(3),t wo longer pads in posit ion 1 and
3, two shorter pads in posit ion 2 and 4. Finally set t he
machine upright again.
Warm t ip:
Noise reduct ion pad is opt ional , could help t o reduce
noise , please assemble it or not according t o your
own demand.
10.3 Dismantle the transportation bolts
The t ransport at ion bolt s are designed for clamping
ant i- vibrat ion component s inside t he appliance during
t ransport at ion to prevent inner damage.
1.
Remove all 4 bolt s on t he rear side and t ake out
plast ic spacers (Fig. 10- 2)(Fig. 10- 3).
2.
Fill left holes wit h blanking plugs (Fig. 10- 4)(Fig. 10- 5).
pads and remove t he
ective film; the noise redu-
10- Inst allat ion
10- 1
noise
2x
2x
(1)
(2)
(3)
10- 2
10- 3
10- 4
10- 5
25
Publicidad
