Samsung DA68 Manual Del Usuario página 30

Installation
STEP 2 Flooring
STEP 3 Installing as a standalone product
CAUTION
When installing as a standalone product, make sure to install brackets or supports to
prevent the product from tipping over.
Important
• If using the product, which is narrow, as a standalone unit, you must install the included
brackets or supports and thereby prevent the product from shaking and tilting. If you
use the product without installing the brackets or supports on the product's rear, the
weight of the refrigerator's door and the food stored inside the refrigerator can cause
the product to tilt and fall over (on to the door side).
• If installing as a standalone unit, you may need to set the product next to a cabinet
or install brackets or supports. Please consult your installation technician on the
installation spot and method.
- If installing supports, you need minimum 10 cm of clearance on left and right sides
of the product.
CAUTION
• If brackets or supports are not installed, the product could topple over and cause a
serious injury.
• Use of brackets or supports is strongly recommended if installing the product as a
standalone unit.
• Make sure to install the brackets or supports whenever you relocate the product (such
as after moving to a new home).
• Do not hang on the refrigerator's door while it's open.
• Check the refrigerator's level after installing.
• When installing the supports, carefully lay the refrigerator down on the floor while
being mindful not to damage the floor.
• When pushing the product in, make sure the power cord does not get stuck between the
brackets.
30 English
Untitled-6 30
• The surface to install the refrigerator
must support a fully loaded refrigerator.
• To protect the floor, put a large piece
of cardboard on each foot of the
refrigerator.
• Once the refrigerator is in its final
position, do not move it unless
necessary to protect the floor. If you
have to, use a thick paper or cloth such
as old carpet along the movement path.
2021-07-09 12:23:41