Preparation For Use - Leak Testing; First Use - Griddle Burn-Off - Pit Boss SPORTSMAN PB2BSPD Manual Del Propietário

PREPARATION FOR USE – LEAK TESTING
A leak test is used to determine the integrity of a seal. Before using your gas griddle, perform a leak test on the connection
between the regulator and the gas cylinder to reduce the risk of serious bodily injury or death from fire or explosion. A leak test
should be performed a minimum of once a season, as well as:
• before lighting your griddle for the first time,
• every time the gas cylinder has been changed,
• after travel, especially over rough or bumpy roads,
• after a prolonged period of storage or non-use.
HOW TO PERFORM A LEAK TEST
Supplies Required:
Bowl ( empty, clean )
1 x
Paint Brush ( clean )
1 x
Dish Washing Liquid
Water
Procedure:
1. Position the griddle in a well-ventilated area. Ensure the griddle is cool to the touch, and not in use. Verify that the
regulator value is turned to the OFF position and that the gas cylinder is tightened securely to the regulator.
IMPORTANT: Ensure there is no open flame or smokers nearby.
2. Mix a solution of one part of water with one part of dish washing liquid in a bowl. The solution will make bubble,
as it will be concentrated.
3. Use a paint brush to apply the solution onto the seal between the regulator and the gas cylinder. Visually inspect for
streams of bubbles coming from a defect or break in the seal.
NOTE: If a leak appears, repeat gas cylinder installation procedure, but do not over-tighten. Hand-tighten
only. Repeat leak test after re-installation to ensure seal is secure.
IMPORTANT: Do not use the gas griddle if you detect a gas leak that cannot be corrected by using the leak
test procedure. Contact your local Fire Department or Customer Service for alternative measures of testing
to ensure proper precaution.
FIRST USE – GRIDDLE BURN-OFF
Before using your griddle for the first time with food, it is important to complete a burn-off. Start the griddle and operate for a
minimum of 15 minutes on HIGH to burn-off the unit. This will "heat clean" the internal components, dissipate odors and rid it of
any foreign matter.
Watch for bubbles
7